Cell-laden printing is the most commonly used approach in 3D bioprinting. One of the major drawbacks of cell-laden printing is that cell viability is highly affected by the extrusion pressure and shear force in the printing process. We present a new cell-deposition method by using the superabsorbent capability of 3D printed scaffolds with four ink formations: 20:10 nanocrystal/alginate (NCA 20/10), 20:10 nanofiber/alginate (NFA 20/10), 20:02 nanocrystal/alginate (NCA 20/02) and 20:02 nanofiber/alginate (NFA 20/02). Limited pores were observed from the surface of inherent NCA and NFA scaffolds, which may limit the numbers of cells to enter into the scaffolds. Therefore, we designed a dual-porous (DP) structure to connect the inherent pores (IPs) to the scaffold surface. Due to these porous structures, NCA and NFA scaffolds exhibit an excellent capability to absorb cell suspension, which may be used for depositing cells to 3D-printed scaffolds, namely self-absorbent (SA) deposition. Compared to the conventional top-loading (TL) method, the SA method had more uniform cell distributions in the entire 3D-printed scaffolds and higher efficiency of cell deposition. For the TL method, DP scaffold exhibited a more uniform cell distribution, which may provide a better microenvironment for the cells in comparison to the IP scaffold. For both cell loading methods, a rapid increase of cell number was observed in the first 4 days of culture in the 3D-printed NCA and NFA structures. NFA 20/02 exhibits the best cell viability compared to the other three inks. In conclusion, the SA method may serve as a new approach for loading cells in cell-free 3D-bioprinting, and DP design could improve the efficiency of the cell deposition.